Genuine Original Quality Motorcycle Mirrors by FAR Italy



Ducati 959/1299 Panigale Carbon LED mirrors 7039/40 - Pair

Regular price $295.00

Ducati 959/1299 Panigale Carbon LED mirrors 7039/40 - Pair

Folding mirrors for the Ducati 959/1299 Panigale.

Also fits the 2016 and later 1199 Panigale R

Drops in the stock fairing mounts, no mods to the bike.

Includes LED ballast resistors.

Lifetime warranty through Moto-Science on LEDS.

Bolts on fairing in 5 minutes, can be wired as running lights or turn signals 

with our passive magic blinker modules: http://www.moto-science.com/product/magic-blinker-led-running-lights-module-pair

Dark Carbon look matches real Ducati Carbon pieces.

Bright LEDS

Includes gaskets and connectors which fit either Ducati 959 or 1299.

Moto-science exclusive, Made in Italy

Ducati 959/1299 Mirror Installation instructions :

Dissemble the mounts, remove 11mm brass nut, spring, Black Alu cover.

Install beveled bases, high side of the base towards the back or rider,

one at a time.

Install black alloy base cover. Install the mirror, add some grease to the base of the mirror if you plan on folding the mirrors in alot and hand tension the 11mm nut hand tight. ( Do not use a ratchet, hand tight here )

Check for geometry. If the mirror is drooping, bases are reversed or backwards.

Thread wire through the hole in the arm pivot.

Install blue resistor across the + and - wires of the mirror at the union of the white connectors is the best location to do this, tape it up. During prolonged turn signal operation the resistor will heat up, this is normal.

Wire up LEDS, check for operation. If you have polarity reversed, reverse the wiring and Pull the key out completely to reset the ECU. Once everything is working, finalize your wiring.

Test ride the bike, and torque mirror spring to your requirements ( folding or non-folding tension)

When you are satisfied with the details: Install Black Plastic Caps marked on the inside, SX for Left, DX for Right.

These caps can be removed after installation with a wedge-shaped chop stick working from the top to the side.

Do not use a metal screwdriver to remove the Black plastic cap as you will chip the powder coating.